JSmall
Bronco Guru
- Joined
- Feb 18, 2004
- Messages
- 3,223
If there is anyone out there that needs the use of a garage, tubing bender, and welder to fab up a cage or bumpers or anything else you can think of let me know. I am in need of:
-D44 w/ 4.10 gears
-Flares frt./rear
-Rear seat
-Disk brake set-up
-More than likely any other part you can think of
And anyone experienced in installing sheet metal that I have coming that would be willing to help me out so I don’t mess anything up. Let me know because I have the bender sitting there not being used most of the time. I only have a 1.75” die right now. If nothing else it would be a great way to meet a few other Bronco enthusiasts. You can either reply to this post or email me at jaromy.smallwood@nike.com
Thanks
-D44 w/ 4.10 gears
-Flares frt./rear
-Rear seat
-Disk brake set-up
-More than likely any other part you can think of
And anyone experienced in installing sheet metal that I have coming that would be willing to help me out so I don’t mess anything up. Let me know because I have the bender sitting there not being used most of the time. I only have a 1.75” die right now. If nothing else it would be a great way to meet a few other Bronco enthusiasts. You can either reply to this post or email me at jaromy.smallwood@nike.com
Thanks