Unknown shims in Dana 20

[Lando375]

I tore the Dana 20 apart a few days ago and kept is all organized, so I thought. I have the three shims for the output shaft above the speedo gear. For some reason I though there were some for the input shaft. Either way I have two thicker shims that are the same size as the three output shims but I don't remember where they went. Is it possible they were with the other shims. So possibly five output shaft shims. The only other thing is under the yoke because they don't fit over and other shaft. Any help would be greatly appreciated.

Here is a picture of the two thicker shims. The three output shims are on top.

 

[Viperwolf1]

Those are all for the rear output. Should be somewhere around .075" total thickness.

 

[Lando375]

Thanks! I just measure them. They are .098 total thickness. I take it the thinner shims get sandwich in between the two thicker ones, correct?