Xtreme 4x4 9in

[bigmuddy]

I wouldn't waste my time with the eldorado calipers for rear disc brakes, most will tell you if they are working now, they won't be in short order. I had a set and could never get them adjusted to work properly, particularly the e-brake function.

Ben

 

[78Scronco]

If you want to get rid of the disk wiggle use Dorman wheel studs part # 132
u will have to drill out your axle shaft to 5/8 to install these studs but they will get rid of the disk sloppyness.

I used 14bolt brackets from ballistic fabrication and ford D44 rotors

on your 9" you used 14 bolt brackets? How? i'm wondering because they sure would seem to be bigger.

 

[broncodude_73]

I cut 3/4'' out of the radius that sits on the tube. Why did I do this? because somebody else bought em and they had sat in the shop for a while, so i put em to use.

 

[craigellis77]

A 2wd Chevrolet rotor from 73-87 should be 5 on 5 1/2.

 

[wpaeb]

yes But the hub is an integral part of those. Ford, jeep , or dodge.

hth

 

[scsm76]

A 2wd Chevrolet rotor from 73-87 should be 5 on 5 1/2.

There 5 on 5"