I had both towers in and the crossbar built. I tacked it on to make sure it would work and then removed it so I could make it easily removed. I drilled and tapped the top of the tower and added a pad for the support bar to weld to.
I added a temp support bar between the rear towers until I get the fenders in. When the fenders go in I will cut down the bar and sandwich the sheetmetal with plates so the rear is fully enclosed.
I finished Sunday by mocking up the tire. I was happy at this point.
The next morning I got up and cycled the suspension to check my clearances. That's where I ran into my setback. I didn't plan to tube out the front until I was completely done with the suspension. It won't be able to wait.
I wanted to use the knuckle gusset for the lower strut mount and that has led to the issue I'm having now. The struts should be mounted at a 10* angle towards the middle and with that angle, the tire hits the strut. At
stuff. I thought that might happen so I had other brackets on hand. I cutoff the lower mounts and the towers so I'll be working on the new setup soon.