dana 20 bushings to cross member bracket torque spec

[ren56]

would like the torque specs c-4 bushing to cross member bracket

 

[bronconut73]

"Just don't smash the bushing too much" is pretty much the process I followed, lol.

If no body has done so yet,
Welcome to ClasicBroncos.com.

Best site on the net.

Some body may chime in with a torque spec.
Bump to the top.

 

[JWMcCrary]

The ones the vendors sell have a sleeve with washers as big as the bushing. I use an impact wrench and let it grunt. Never had a problem.

 

[DirtDonk]

Factory was 45-55 lbs, then whatever it takes to align the cotter pin hole with the castle nut.

That design used a sleeve too, but I don't remember if it was oriented in such a way as to limit the compression of the bushings.

Paul