I was rebuilding my heater box and wasn't quite happy with how the EEC box was mounted. I have seen several people ask how to do it so here is one method.
I recycled the diamond plate from the previous method and attached a piece of angle AL with 3M urethane foam tape.
It mounts at the top behind my electrical panel and is hidden when panel is installed
The 'puter is wrapped with heavy rubber (hey it looks like the floor mat?). there is probably a better looking way to make a computer condom.
the diamond plate is bent to provide a spring force. Pull it back and the computer slides up and in.
No screws were needed and the puter doesn't move
The computer needs a good ground. if you wrap with an insulator the case is not grounded like a factory installation. You can add an addition ground or at least make sure the computer's other grounds are secure.
I recycled the diamond plate from the previous method and attached a piece of angle AL with 3M urethane foam tape.
It mounts at the top behind my electrical panel and is hidden when panel is installed
The 'puter is wrapped with heavy rubber (hey it looks like the floor mat?). there is probably a better looking way to make a computer condom.
the diamond plate is bent to provide a spring force. Pull it back and the computer slides up and in.
No screws were needed and the puter doesn't move
The computer needs a good ground. if you wrap with an insulator the case is not grounded like a factory installation. You can add an addition ground or at least make sure the computer's other grounds are secure.











