hydroboost "porting"
OK OK quit nagging!!! here is the short version on improving an hydroboost unit.
The following items I am going to assume you already have:
A good hydroboost, out of the truck.
A Saginaw power steering pump, preferably a one ton unit
Dual returns on the pump body.
Good large pressure lines.
We are going to deal with the HBoost only!! the pump is another issue
Remember, HBoost is parasitic, and only uses fluid pressure when it is in use
Now lets deal with the "porting", tuning would be a better word.
Take the unit apart completely and we are dealing with the main body with the three ports on it. We take it apart to keep things clean and believe me a small sliver of metal in the spool valve area of the HBoost will permanently destroy the unit. CLEANLINESS is the word here.
Now, we want to increase the size of the high pressure ports at least a little larger than stock. take your unit and measure the ID of the high pressure port from the pump. take this measurement and get a drill bit one size bigger than this measurement and drill out the port carefully. Do not score the inside of the unit as this will definitely ruin your day and unit. I have gone two drill sizes with inverted flare units but bubble flare is not as forgiveing and one size is all they can stand. drill it out slowly and smoothly so you get a smooth channel. trick here is to ensure the port on the inside of the unit is smooth as a babies bum because roughness will cause the seals to rip and you will learn how to rebuild a unit quickly. clean and smooth are the words.
Do the same with other high pressure port again careful you do not score the inside of the unit or you will be looking for another body.
Now the Low Pressure return or as they say the pressure bleed port.
This one I threaded for a large fitting, I went significantly larger because of the fitting I used. match the size of the fitting (ID of the fitting) and drill this out on the body. Again don't score the valve area.
Put your LP fitting on and ensure it stays on and seals I usually epoxy mine onto the unit.
wash the body and wash it again. if its not clean enough to eat off its not clean enough. Mine went into a large boiling pot with the cleaning mixture in it (even amounts of water and varsol with Cascade dish washing soap added) boiled to death for 1/2 hour. OUTSIDE guys this mixture is potent.
assemble the unit and this will handle just about anything you throw at it.
The super duper ultra magnum killer mod setup has other tricks used on it and cost a lot of money to do but you will not need that one unless you are running 44's on rockwells or similar such ilk.
TOFIC