• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

speedy sleeve

kancox

Full Member
Joined
Jan 25, 2009
Messages
250
does anybody know if they make a speedy sleeve for the seal surface of a d44 spindle?
 

bmc69

Contributor
Bronco Guru
Joined
Jun 11, 2004
Messages
12,015
I use Speedi sleeves on spindles all the time..in fact, even install them on perfectly fine spindles for my trail rigs because that makes the seal better than stock.

You do have to make you own installation 'tool'..a piece of pipe with the ID only slightly larger than the OD of the Speedi Sleeve. After you have installed the sleeve, you trim the excess lenght off with a Dremel cutof wheel and dress it with a file..all Speedi sleeves are too long for the spindle seal area.
 

methcat

Sr. Member
Joined
May 28, 2009
Messages
385
Loc.
long beach
if there is still some good surface on the shaft, you can sometimes get away with putting the seal in a different location. some of the seals are thinner, giving you more leeway on how deep to put them in. i did that on one of mine and it worked great.

oops, i did that on my 9", forgot 44's have the lip. not sure if they can be set different or not...
 
OP
OP
K

kancox

Full Member
Joined
Jan 25, 2009
Messages
250
I use Speedi sleeves on spindles all the time..in fact, even install them on perfectly fine spindles for my trail rigs because that makes the seal better than stock.

You do have to make you own installation 'tool'..a piece of pipe with the ID only slightly larger than the OD of the Speedi Sleeve. After you have installed the sleeve, you trim the excess lenght off with a Dremel cutof wheel and dress it with a file..all Speedi sleeves are too long for the spindle seal area.

I was thinking take a hole saw to the install tool large enough to fit over the spindle then a pipe .On the link above they list 3 or4 that would work acording to what mine measured.Do you by any chance know what the stock number is that you use?THANKS
 
Top