• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Line-X Question

hayes1699

New Member
Joined
Apr 20, 2010
Messages
15
Loc.
Atlanta, GA
IMG_1471.JPG


Hey guys, has anyone heard of bullet liner? I am taking my truck to line-x tomorrow but considering this new product.

My real question that I am concerned about though is about "OVER THE RAIL". I have a hard top and I don't want it scratching the new nice paint on the rail it sit on. If i get the bronco line-x'd over the rail, are there any negatives? For example, will the hard top still sit right?

Also, my truck got painted 2 days ago and I am on a time crunch. What are the potential negatives to not waiting on the paint to cure?

Thanks in advance

Hayes1699
 

IFLYHOOKS

Full Member
Joined
Dec 11, 2009
Messages
219
Loc.
Clarksville
You don't want to go over the rail with Line-x; it will cause your top to sit too high to properly mate with the top of the windshield. I had my fiberglass tub Line-x'd inside, underside and engine compartment and it looks great.
 

The Mule

New Member
Joined
Sep 21, 2008
Messages
46
Negatives to having it line-x so soon after paint is that the tape they use is very, very sticky and will peel the paint right off. I had one done and it peeled the paint at the top of the door. You will definately know how good your body prep was when they remove the tape. My was lined about 4 months after paint and after setting in a hot Texas shop all summer. Other than that it turned out great and looks to be very durable.
 

Tuck

Sr. Member
Joined
Jul 25, 2001
Messages
947
You don't want to go over the rail with Line-x; it will cause your top to sit too high to properly mate with the top of the windshield.

Absolutely true. My Line-X goes over the rail & the front of the top has a huge gap between it and the windshield frame. I'm not sure how I'm going to address it. With the seals, it's even worse. I thought about just going with a soft top & be done with it, but I haven't made my mind up yet.
 

dlong

Jr. Member
Joined
Feb 28, 2011
Messages
57
Loc.
Las Vegas
So a soft top will fit if the bed rails are Line X? I'm looking to have mine Line X and have a Best Soft top to install
 
OP
OP
H

hayes1699

New Member
Joined
Apr 20, 2010
Messages
15
Loc.
Atlanta, GA
Absolutely true. My Line-X goes over the rail & the front of the top has a huge gap between it and the windshield frame. I'm not sure how I'm going to address it. With the seals, it's even worse. I thought about just going with a soft top & be done with it, but I haven't made my mind up yet.


thanks guys, It looks like I will not go over the rail, and I am waiting until monday to do the bullet liner. Thanks again
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Not sure last time i checked linex wouldnt do over the rail so I went with rhino liner. I rather like over the rail dont really know if its needed on a bronco but I really dont see it causing much of a issue you could always double up on the front weather strip or just add some RTV. but I doubt you would really need to the line x is only about 1/16" thick.
 

JohnJohn

Contributor
Bronco Guru
Joined
May 6, 2005
Messages
2,179
Loc.
Richmond
Mos

One thing to note is they will start out glossy then fade in sunlight. Linex offers a top coat bit it almost doubles the cost.
 

deltarat

Bronco Guru
Joined
Jul 12, 2006
Messages
3,371
Loc.
Drew,Ms
LineX will go over the rails. I did my 1/2 cab over the rails.except under the top. They recommended to wait 6 weeks after paint, I think, before you Linex.
 

chriswitt

Full Member
Joined
Nov 26, 2009
Messages
191
I went over the rails but kept it exactly under where the top sits. I did not want to see the Rhino when the top is on. I also have new paint. I wanted to protect the top rails from scratching while the top goes on. Also i had small dimples at each hole from the PO tightening the bolts on the top down. The Rhino just about completely hides the dimples around the holes. My logic was to eliminate the top rail weather strip that was on the truck as the Rhino would take up this space (both about 1/16" thick). I hoped that it would fit the top windshield ..... no?
 

Devin

Bronco Kineticist
Joined
Apr 29, 2004
Messages
3,956
I went over the rail with my Line-X. The top seems to sit ok - not perfect, but ok. But, nothing else on my truck lines up perfect, anyway - so it's all good. ;D
 

trailpsycho

Bronco Guru
Joined
Dec 11, 2003
Messages
4,856
Definitely go over the rails...if your going to be taking the hard top on and off, it will protect the bed-rail.

I cant speak for the fitment of the top at the windshield frame. But a 1/8" strip of steel (or aluminum) and two seals should take up any gap...and there are several ways to address the doors, if necessary.

The soft top fits great, so no worries there.
 

backpain

Bronco Guru
Joined
Oct 2, 2007
Messages
1,094
Tuck, line-x the top of the windshield frame to compensate for the difference....????
...and weld in filler for the door frames or split the difference between top and bottom door gaps (which then challenges your windshield gap, and then . . . . it get's complicated if you are trying to seal it up and have body lines look good, stock doors and top on, etc

My preference is for a thinner protective solution (really thin bedliner maybe, 3M clear tape/rock guard, etc) and cap the rails with something that looks nice (diamond plate covers or whatever) if you have to hide abrasion later.

I don't use the bed stakes either.
 

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Went over the rails and the tops sits just fine. My only concern is when I go to paint it again. Worried about how to do prep with the liner along the edge of the paint. I'm sure it will be easier than I think, but...
I like that I don't scratch the paint when taking the top on and off.
 
Top