Tedster100
Chairman of the Bored
- Joined
- Aug 25, 2010
- Messages
- 1,762
Well, after nearly completing my build I couldn't get the old 302 to run right. Pulled my hair out trying to figure it out cause they're really not that complicated. I completely we through every part of the bronco including the tranny & transfer case and cleaned, replaced or painted every part, nut & bolt. The motor was the only thing I didn't do myself and I finally decided that the only solution was to pull the motor back out and go through it myself so that I was confident I could depend on it and lookie what I found!
The motor had been rebuilt many years (19) ago and sat inside the whole time. Somehow the little bas#%$ds got in there and left me a baseball size glob of insulation. Also had some problems with valve guides that was causing the motor not to run correctly, thank God, otherwise that fiberglass would have eventually blown her up. That's exactly where I found the insluaton in addition to the wad in the oil pick-up.
So now I've got the block striped down and in the shop for some new bearings and a good flushing. Figured I'd replace the cam, valves & springs, intake and water pump while I was at it. At least now I'll be able to know it will be dependable. Go figure.
The motor had been rebuilt many years (19) ago and sat inside the whole time. Somehow the little bas#%$ds got in there and left me a baseball size glob of insulation. Also had some problems with valve guides that was causing the motor not to run correctly, thank God, otherwise that fiberglass would have eventually blown her up. That's exactly where I found the insluaton in addition to the wad in the oil pick-up.
So now I've got the block striped down and in the shop for some new bearings and a good flushing. Figured I'd replace the cam, valves & springs, intake and water pump while I was at it. At least now I'll be able to know it will be dependable. Go figure.











