I can tell you one thing. After you install the nut zerts test fit the tailgate to make sure it fits and works before paint. I bought a Bronco that was filled with new sheetmetal and had a new tailgate from Duffs so I painted it to match my red bronco, assembled it and installed nut zerts and when they built the tailgate and spotwelded it together the handle area is offset about an 1/8" so the pin on the pass side will not pull in far enough because it is off center. Now I have to weld up the holes for the latch, re-center and repaint it one of these days to correct the issue or modify one of the rods going to the pin to make it a tad shorter to get the tailgate to work. Nutzerts work great. I am an HVAC guy so I have the proper tools to compress them. I use the ones that have a rubber o-ring gasket on them to help keep from spinning and marring the paint.