Scott C.
Sr. Member
It sounds like you are adjusting them properly. Have you tried adjusting them with out the engine running? TDC compression stroke of each cylinder, zero lash ans then 1/2 to 1 full turn. It should not make any differance dead or running.
What is your timing set at? Is the vacume and mechanical advances both working properly?
Do you ever get the noise to go away at all?
Are the rockers new too with that new shaft?
Can you wiggle any of the valves by hand?
Are you locking the rocker screws in place with the jam nuts? If, it has them?
Have you checked averything we have mentioned?
What is your timing set at? Is the vacume and mechanical advances both working properly?
Do you ever get the noise to go away at all?
Are the rockers new too with that new shaft?
Can you wiggle any of the valves by hand?
Are you locking the rocker screws in place with the jam nuts? If, it has them?
Have you checked averything we have mentioned?











