• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Banjo bolt torque

Pops68

Contributor
Bronco Rookie
Joined
Oct 11, 2010
Messages
1,777
Loc.
Bazetta Township
OK, thought I had this yesterday, but I didn't.

How many ft lbs or inch lbs do you torque the banjo bolts to on the chevy front disc conversion??
Don't want a leak or to ruin the 2 brass crush washers.

Thanks!

Pops
 

JWMcCrary

Contributor
Bronco Guru
Joined
Oct 14, 2004
Messages
5,001
OK, thought I had this yesterday, but I didn't.

How many ft lbs or inch lbs do you torque the banjo bolts to on the chevy front disc conversion??
Don't want a leak or to ruin the 2 brass crush washers.

Thanks!

Pops

Just get it tight, I have never put a torque wrench on one. Just use a medium length wrench and get "tight" with one hand.

Nothing wrong with following the torque specs but I have turned every bolt on my Bronco over the past 10+ years and the only thing I have ever torqued is the mains, rod caps, and head bolts. I'm not suggesting that to anybody, just saying some common sense and feel can work just fine.
 
OP
OP
Pops68

Pops68

Contributor
Bronco Rookie
Joined
Oct 11, 2010
Messages
1,777
Loc.
Bazetta Township
JW and Savage.....THANKS....will tighten as suggested.

Only problem left is I stripped the nut on the passenger side where the hard line meets the rubber line. Keep soaking in PB Blaster till tomorrow, then will try one last time to remove before cutting the hard line, buying several new flare nuts, reflaring the end and trying that. If that is a no go, then I will need to buy or make a new line.

Pops
 
Top