PABrian
Full Member
I'm thinking of making a set of these. would they work with out the bend?
With the 1/4 wall tube of the Lars bars, a cheap harbor freight tube kinker does a great job of bending them too.
I am not bending mine. The following issues will allow me to use the sexier straight (!) look.
1. full width axles. The wedges aim directly at where the new pivot point is.
2. negative offset Humvee rims. 37" tires. Not tested the turning radius yet, but I believe it will clear.
3. extra length arms. I am adding 12-14 inches to the arms from old pivot to new pivot
4. I am correcting the caster by bending the upper part of the forged existing arm by about ten degrees to compensate for the six inch lift. This will also straighten the massive forwrd bow on my coil springs. I still need to address the issue of locating the lower spring cups directly under the uppers. Or moving the uppers out. Or angling the lowers inward to aim the spring directly at the upper cup. Any ideas on that?
Have you thought about your pinion angle? Just rolling the axle back is great for caster, but will kill your front pinion angle, especially with so much lift. I'm currently putting full width F150 axles under mine with 3.5" lift and will be rotating the knuckles so that I can have good caster and pinion angle.
If he's doing a hi-pinion, he can roll it back plenty, and the pinion angle still won't be an issue like a LP44.
Mark






