I was talking everything I posted above with a Big Bronco buddy at lunch today. He's also a pretty damn good mechanic and we both sell electrical stuff. (you'd think I would know more about this crap) That melting is EXACTLY what I'm worried about when it comes to the orange wire. It is undersized. (looks 18AWG and at best is 16AWG) That Walbro unit I referenced above is calling for a 10AWG wire, which is probably overkill, but can't be by that much. I'm thinking 12AWG to 14AWG will be about right, but any smaller can't be right for these pumps. The Carter P4070 installation instructions call for a 14AWG wire and draws less amps for sure.
I wrote to FI Tech about the undersized wire and have not heard back yet.
We discussed the relay upstream of the FI Tech unit like Bteutsch has described and that all makes sense now and should be fine to power the ECU / HP pump. My thoughts is that if I have any problems with the orange wire being undersized, I can run the HP pump directly from the relay on a second circuit and bypass the computer. I won't get have the advantage of extending the life of the HP pump, but I also won't have melted wires, connections, etc, right?
Will the computer freak out if it doesn't get a signal in that the HP pump is running? Guess I need to call Bryce to clarify, but that's the plan. Relay upstream of white wire and run HP pump off other wire. If any problems arise, bypass unit for the pump's power and run it separately from the relay to the pump. We'll see what the FIT Gurus say.
As far as putting a relay in and using the orange wire as signal, I don't think it's possible. Lowering the voltage on the signal of a relay will cause it to chatter and fail before too long, right? I work for company that reps ABB and Thomas & Betts and we see that problem on drilling rigs and in the plants. My buddy talked about that today as well and said no way / no how. Lowering the voltage on the signal wire does not translate to lowering the voltage on the power side of the relay, which is what they're after.
Funny thing, I already had another window open and was reading up on it.
http://www.appliancedesign.com/articles/91388-switches-relays-cut-the-chatter
I'd say that won't be a solution, unless I'm missing something. I'm going to be looking into powering the HP Pump / Fuel Command Center separately from the FIT unit and will report back.
Please don't judge that I struggle with electrical, yet sell medium voltage breakers and contactors. I'm just an oilfield hand that worked for Enron for 10 years and BS'd my way into an electrical sales job after the bankruptcy! (shows I can lay it on thick!)
Heading out there now to start pulling wires and re-route my fuel lines. Will report back!