KeithKinPhx
Sr. Member
- Joined
- Jan 8, 2017
- Messages
- 451
Hi. I’m restoring my 68 and am starting to mount equipment to the firewall such as the heater box, accelerator cable and brake cable. Given the rust I’ve found and removed on my floor pans and under the dash I would like to seal up all the openings as weather tight as possible. Not to mention keeping engine fumes out too.
I have the weather stripping kits but there as still small gaps where the opening for the heater box goes thru the wall. Same for the accelerator assembly.
I just painted the bay a beautiful peacock blue, purchased a stainless steel bolt kit and don’t want to ruin it with big blobs of black goo. Kind of would ruin the look if you know what I mean.
What is recommended to seal the gaps? Should it be applied from the cab side rather than the engine bay?
I appreciate that I may be over thinking this but after all the hours and money to get it this far, jacking it up at this stage would be a shame/crime.
Thanks, Keith
I have the weather stripping kits but there as still small gaps where the opening for the heater box goes thru the wall. Same for the accelerator assembly.
I just painted the bay a beautiful peacock blue, purchased a stainless steel bolt kit and don’t want to ruin it with big blobs of black goo. Kind of would ruin the look if you know what I mean.
What is recommended to seal the gaps? Should it be applied from the cab side rather than the engine bay?
I appreciate that I may be over thinking this but after all the hours and money to get it this far, jacking it up at this stage would be a shame/crime.
Thanks, Keith
Last edited:











