• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

US Shift/Baumann Quick 4 problem...

nvrstuk

Contributor
Just a Bronco driver for over 50 yrs!
Joined
Jul 31, 2001
Messages
10,622
Loc.
PNW
So, been running the Optishift for over 10 yrs. Flawless.

Upgraded to the Quick4 since it was cheap and I am pulling my 4r70 and controller for later use.


OK... disconnected my wiring from the Quick4 which I have used for 2 months. Pulled it and all my wiring out of my console to work on the console. Worked on my Bronco for 2 weeks. Plugged the Quick4 in today so I could back my Bronco out and cut my paint.

I turn the ignition on, fuel pump builds pressure then WAIT...what the heck is that CLICKING noise coming from the trans??

Shut key off, do it again, same result. Checked all connections inside my rig, on the trans, all grounds are ok. About 5 hrs into trying to find something.

NO fault codes just reads "1Ft" or in 5 seconds "Ft".

Very loud clicking like a solenoid is cycling 2x/second.

Any clues. Have emails, phone calls, and texts into Jake, not kevin at US.

After 20+ yrs I STILL wish we could post short videos... lol
 
OP
OP
nvrstuk

nvrstuk

Contributor
Just a Bronco driver for over 50 yrs!
Joined
Jul 31, 2001
Messages
10,622
Loc.
PNW
Kevin doesn't answer the phone much anymore... :(
 
OP
OP
nvrstuk

nvrstuk

Contributor
Just a Bronco driver for over 50 yrs!
Joined
Jul 31, 2001
Messages
10,622
Loc.
PNW
OK...out there at 6am... checking voltage after running grd continuity checks which I did yeaterday too. All OK.

Turn the key on while moving the controller and the clicking stopped after the display changed to P (like it should). Key off then back on, clicking back- gently touched one of the wires in the 16 pin connector and the clicking stopped, then immediately back.

Must have a pin in that connector making "visual" contact but not good electrical contact. Not the pwr or grd because the display always stays "on".

I will tweak each pin to see if I can make it have better contact inside the connector when plugged in. Visually you can see all the pins in their correct physical location in the 16 pin connector.

I'd moved and wiggled this thing 2 dozen times yesterday and just lucky it made a difference this am when moving it. I was standing outside the PS door this am. Must have made the difference. ;)
 
OP
OP
nvrstuk

nvrstuk

Contributor
Just a Bronco driver for over 50 yrs!
Joined
Jul 31, 2001
Messages
10,622
Loc.
PNW
Put slight pressure on it so it will make more solid physical contact till my "pin puller" arrives and I solder new pins on then install it...all for a week then I remove this combo for a future build and start on the 6r80 build.
 
Top