Hello all- how much carb cleaner is too much to run through your carb? I put 1.5 spray cans through it about a month/1 gas tank ago (half of one can was used to clean up all the levers/mechanisms on the outside of carb). It greatly improved the performance, but engine still shuts off occasionally/smells fairly strongly of gas- I was told that my needle is likely stuck/has sone grit in it, as I had just changed the in-line fuel filter right before this all happened (although it had been shutting off at low idle BEFORE new filter). T y in advance- Bryan
Speaking as a long-time carb rebuilder (even owned a carb rebuild shop back in the 80s):
1. The composite floats in the Motorcraft carbs always gain weight over time, even faster with ethanol in the gas. That's the #1 cause of high fuel bowl levels. For reasons I've never understood, nearly all rebuild kits do NOT include the float, even though tis mandatory for any rebuild. You ahve to order the float separately,
2. Any of the "spray though the carb" cleaners are gimmicks. They do little of nothing except make ya feel like you accomplished something. ;-)
3. The brass emulsion tubes that feed the boost venturi are often split lengthwise due to age and brass embrittlement...a process that is accelerated a lot by ehtanol in the gas. That failure of the tubes causes crappy idle and off-idle performance.