• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Carb cleaner

bryan

Jr. Member
Joined
Dec 22, 2004
Messages
67
Loc.
Charlotte
Hello all- how much carb cleaner is too much to run through your carb? I put 1.5 spray cans through it about a month/1 gas tank ago (half of one can was used to clean up all the levers/mechanisms on the outside of carb). It greatly improved the performance, but engine still shuts off occasionally/smells fairly strongly of gas- I was told that my needle is likely stuck/has sone grit in it, as I had just changed the in-line fuel filter right before this all happened (although it had been shutting off at low idle BEFORE new filter). T y in advance- Bryan
 

TNcowboy

Full Member
Joined
Aug 29, 2019
Messages
220
Probably be a good time to rebuild your carburetor. I've become a believer in the use of ultrasonic cleaner to clean everything after disassembly. I had issues with a 1100 carb that I soaked in chemdip more than once and still had a stumble. Cleaned it with the ultrasonic and it runs great. BTW simple green works great in the ultrasonic so you can avoid chemdip
 

bmc69

Contributor
Bronco Guru
Joined
Jun 11, 2004
Messages
12,015
Hello all- how much carb cleaner is too much to run through your carb? I put 1.5 spray cans through it about a month/1 gas tank ago (half of one can was used to clean up all the levers/mechanisms on the outside of carb). It greatly improved the performance, but engine still shuts off occasionally/smells fairly strongly of gas- I was told that my needle is likely stuck/has sone grit in it, as I had just changed the in-line fuel filter right before this all happened (although it had been shutting off at low idle BEFORE new filter). T y in advance- Bryan
Speaking as a long-time carb rebuilder (even owned a carb rebuild shop back in the 80s):
1. The composite floats in the Motorcraft carbs always gain weight over time, even faster with ethanol in the gas. That's the #1 cause of high fuel bowl levels. For reasons I've never understood, nearly all rebuild kits do NOT include the float, even though tis mandatory for any rebuild. You ahve to order the float separately,
2. Any of the "spray though the carb" cleaners are gimmicks. They do little of nothing except make ya feel like you accomplished something. ;-)
3. The brass emulsion tubes that feed the boost venturi are often split lengthwise due to age and brass embrittlement...a process that is accelerated a lot by ehtanol in the gas. That failure of the tubes causes crappy idle and off-idle performance.
 

phred

Contributor
Bronco Guru
Joined
Aug 25, 2006
Messages
3,608
Loc.
Earth
Bill are the emulsion tubes available. I’ve got 2 4100’s that need tubes and I was hesitant to try removing them.
 
Top