• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Engine/ transfer angle mock up

68stang73

Sr. Member
Joined
Nov 29, 2015
Messages
399
What's the degree the engine needs to be set angled at? I leveled the intake but the drive shaft angle is extreme. I was wondering if that's correct or if it needs to be tilted back a few degrees?
 

nvrstuk

Contributor
Just a Bronco driver for over 50 yrs!
Joined
Jul 31, 2001
Messages
10,622
Loc.
PNW
Tilt the engine to help your driveline angle...
 

5001craig

Contributor
Bronco Guru
Joined
Nov 3, 2013
Messages
1,180
Rearward angle down will hurt front driveshaft angle if you have much lift. My engine is at 4.5° down and it is definitely noticeable on the front driveshaft angle.
 

fordguy

Contributor
Bronco Guru
Joined
Jan 23, 2005
Messages
6,361
I am also mocking up my engine and trans. i am sitting at zero on the carb pad, but that is just temporary. Can one of you give me a measurement on drivers side for oil pan rail (bottom of block) to frame. My engine seem to sit about 3/8ths out from front to back. it can easily be corrected just curious what others are measuring.
 

fordguy

Contributor
Bronco Guru
Joined
Jan 23, 2005
Messages
6,361
i could not make anything of it after i blew it up to about 200 percent. will need to look again.
 

fordguy

Contributor
Bronco Guru
Joined
Jan 23, 2005
Messages
6,361
how bout using the crank on the front and the output shaft of the trans? i am going to print the diagram because i still cant read it even with my glasses lol
 

fordguy

Contributor
Bronco Guru
Joined
Jan 23, 2005
Messages
6,361
finally got it where i could read it, appears then engine is one inch to the right of the chassis center line.
 
OP
OP
6

68stang73

Sr. Member
Joined
Nov 29, 2015
Messages
399
I clicked on it but with all that mess I couldn't tell the measurements of the drop of the engine. So I just lowered mine to 4.5-5 degrees on the carb pad. I had to cut into my firewall on drivers side to allow the tall valve cover to clear. I'll have to fab new sheet metal for the gas pedal but Owell that's nothing. Now to figure out a new mounting solution for the trans crossmember
 

Buckshot Bronco

New Member
Joined
Aug 6, 2022
Messages
7
Resurrecting this old thread with a question. I need a angle finder tool to determine the exact angle but I can aready tell I'm over the 5 degree recommended maximum angle. I have the stock HD engine mounts from WH and advance adapters cross member for the AX15 transmission. I plan on jacking the TC until i'm at 5 degrees, measuting the gap between the x-member and trans mount and fabricating a polly spacer? Is this the best solution to leveling out the drive line?
Thanks!!

Engine Angle.jpg
Engine Angle 3.jpg
Trans Crossmember Angle.jpg
 
Top