• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Gas Cap not tightening

75MIKE

Sr. Member
Joined
Aug 22, 2001
Messages
991
Loc.
NE Washington
Last of the finishing touches went to install color match gas caps and they won't tighten. It's on a 1975 so would guess I needed the longer , now I'm not sure. The one e on the left will tighten down, but the new won't . Do I need the earlier cap even though this a a 75? Thanks, Mike
1.jpg
2.jpg
 

serial car restorer

Yes, I'll restore almost anything...
Joined
Aug 27, 2024
Messages
742
Loc.
Western Oregon
I'm thinking the caps need to match the filler necks. My '69 has one of each type. Can't swap them. Apparently one of my filler necks has been replaced some time in the past. When I replace 'em I'll need both types.
 

904Bronco

Contributor
Bronco Guru
Joined
Sep 28, 2004
Messages
6,720
Loc.
San Martin, CA
Sealing gasket on both about the same? Sometimes new ones need a while to compress/break in. Just a Random thought...
 

BronCowie

Contributor
Old Timer
Joined
Apr 24, 2007
Messages
8,290
Loc.
Vancouver, WA
I'm thinking the caps need to match the filler necks. My '69 has one of each type. Can't swap them. Apparently one of my filler necks has been replaced some time in the past. When I replace 'em I'll need both types.
^^^This^^^

My '69 is the same. I need one of both types, non-interchangeable.
 
OP
OP
75MIKE

75MIKE

Sr. Member
Joined
Aug 22, 2001
Messages
991
Loc.
NE Washington
Sealing gasket on both about the same? Sometimes new ones need a while to compress/break in. Just a Random thought...
That's what doesn't make sense. The "correct" one goes too far in and misses the mating surfaces.If I hold it out a little it will catch. I think I will just need to run to NAPA and see if they have one of each and try and figure this out. It's always something. Thanks
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Remember too, that back then it was “a thing“ to do whatever you could to make your vehicle accept leaded fuel pump nozzles. Which a 75 bronco factory filler neck would not have done.
Look down inside and see if it’s necked down or not.
My guess is it’s not, and that at some point in the past, a PO had changed it to an earlier style.
Since they were rarely available new back then, or at least hard to source, It’s very possible they just went to the junkyard and picked one up.
It would certainly look old and original that way.

Did your bronco come with catalytic converters originally?
Does it still have its charcoal canister system?
 
OP
OP
75MIKE

75MIKE

Sr. Member
Joined
Aug 22, 2001
Messages
991
Loc.
NE Washington
I think you are on to something. No necked down filler necks even though the speedometer is a Unleaded Fuel Only. No cats when I bought it in 1990 although it had the burp tank, but the charcoal canister on the frame had been removed. I think unless a person witnessed the Bronco actually driving off the lot, all original is a very loose term. Thank you
 
Top