Painless Harness Instrument Cluster Issues

[Speedrdr]

View attachment 945774

Out of curiosity, is this schematic a “generalized” diagram or is it specific to Painless? I ask because I have an AAW harness (still in the box) and am looking for every cheat sheet I can find..

 

[cldonley]

Out of curiosity, is this schematic a “generalized” diagram or is it specific to Painless? I ask because I have an AAW harness (still in the box) and am looking for every cheat sheet I can find..

This is a Painless diagram.

 

[cldonley]

I'm in the process of my Painless rewire now also. Where did you connect the braided straps to the body?

Sorry for the delayed answer! I went from frame to firewall and frame to body in the back near the rear axle.

 

[73azbronco]

I'd use ohm meter vs voltage to check for good grounds. Disco battery, run a small wire from battery ground cable (not connected to battery) to near backside of instrument cluster, then use an ohmeter from the batt gnd wire to back of instrument cluster to check for resistance.

I would do same for all your ground straps to battery cable, should be close to zero resistance.