scrubtopdoc
New Member
- Joined
- Mar 10, 2025
- Messages
- 4
I just picked up a 1968 bronco and have the frame stripped clean. I see no evidence of damage or repairs anywhere on it. It only has surface rust except for a 1/2" hole in the driver's side frame rail just aft of the shock mount. I checked the measurements based on info from this site (thanks!), and all of the diagonal measurements are spot-on. But when I set the frame on the driveway, which is flat concrete, the passenger side frame rail sticks up about 5/8" at the back. I cant find any frame service around where I live that will look at the frame; they require that it has to be an entire rolling chassis before they can put it on their frame machines. So my question is whether this amount of deviation is acceptable, or does the frame rail need to be straightened?











