Mac2Night
Bronco Guru
- Joined
- Aug 10, 2005
- Messages
- 2,204
I have researched all the old threads on this (they were very helpful) but I still have a quick question about my situation.
Here's the history: Bought the EB almost a year ago and it ran fine; Had a rocker arm come loose (nut split) but repaired it and no issues; About 500 miles ago it started smoking on me but runs stong with good-fair oil pressure;
This weekend, I pulled the driver's side valve cover and found that one of my rocker arms was sitting sideways on the spring and that the rocker arm stud was sitting slightly higher than all the others. It still is tight, but as a quick fix, I added some washers on top of the rocker arm, put the nut back on and tightened it all back up. Lifter not collapsed and the valve/pushrod/lifter all seem to work fine and the oil pressure increased and it runs fine but still smokes.
My mechanic friend told me that I should run it for a while and the smoking will clear up, but it really smokes a lot. What do any of you think about all this?
I realize I need to pull the heads and have the studs replaced as a longterm fix, but I would like to see if the smoking clears up with the valve working properly before pulling everything apart again.
Thanks for any advice you can lend.
Mac
Here's the history: Bought the EB almost a year ago and it ran fine; Had a rocker arm come loose (nut split) but repaired it and no issues; About 500 miles ago it started smoking on me but runs stong with good-fair oil pressure;
This weekend, I pulled the driver's side valve cover and found that one of my rocker arms was sitting sideways on the spring and that the rocker arm stud was sitting slightly higher than all the others. It still is tight, but as a quick fix, I added some washers on top of the rocker arm, put the nut back on and tightened it all back up. Lifter not collapsed and the valve/pushrod/lifter all seem to work fine and the oil pressure increased and it runs fine but still smokes.
My mechanic friend told me that I should run it for a while and the smoking will clear up, but it really smokes a lot. What do any of you think about all this?
I realize I need to pull the heads and have the studs replaced as a longterm fix, but I would like to see if the smoking clears up with the valve working properly before pulling everything apart again.
Thanks for any advice you can lend.
Mac











