Recent content by 7bronco6

I just replaced all 3 u-joints in my rear driveshaft and in the Chilton book for 66-86 bronco it says "To install the front and rear driveshafts, positiion the single u-joint end of the driveshaft to the front axle and install the U-bolts and nuts. Torque to 10-17 ft.lb. Position the double...

I talked to BFG directly a couple weeks ago, because I wanted to order 2 new ones for a locker install and they told me they are redesigning them and they wouldn't be avalable until mid summer, but he couldn't give me a specific date. :(

Talk to Lee at Raceshock. I just ordered a set of of Bilsteins from him. Super nice guy. After asking me a couple measurements similar to yours this is what he said to run. Bilstein AK-7112SB06 7100 Series - 12" Travel Short Body 360/80 Valving

I have the tuffy console so I have it running under the bronco and then coming thru the passenger side and then up along the corner of the windshield. It is suppose to be mounted away from metal, I maybe have it half a inch away? There's two wires on it, One is the antenna and the other is a...

I'm using this. Hidden Antenna

Bronco Driver

22213evl. Click on your name in the upper right. Then click on "Show All Statistics" in upper right. Then it should be right in the middle of the screen "find all posts by" and "find all threads started" Worked for me anyway.

Sorry I wasn't really clear in my first post, I would need to have the driver/passenger dual shock hoops rewelded to the frame. So a total of 4 beads?? So would you think $200-250 if I had a shop do it??

Yeah your exactly right, I guess I'm just doubting my friends capabilities. A little bit. lol

Mapquest is saying hour and 15 minutes. Not that bad.

Sorry typed it in wrong hour and half.

I'm about 30 minutes west of Reading. Mapquest says I'm 1 1/2 hours away.

If I can't find anybody, I might have to drive out there and take you up on that offer. hah Yeah I have some friends that are in the fence business that have a welder, but was going to use them as a last resort.

I have a front double shock hoop that the previous owner must of welded on and the last place I took my Bronco to, the guy mentioned it should be ground down and rewelded. What is a reasonable price I should be looking for in PA? Just to reweld a dual shock hoop. Why is it so hard to find...

Does anyone have the newest KM2's yet? Mud I need to get 2 new ones, and from talking to BFG they changed the tread pattern again and released them early February. There on backorder every where I check though. :(