Recent content by mdm5371

Sold to Sold to ExploerKelly76! Best of luck on the project, keep the pics coming!

Feel free to send any questions to mdm5371@yahoo.com. It's my preferred method for questions so I don't forget what they were.

804 539 1247

Some frame pics

Sent you an email this afternoon.

It's located in Richmond's near west end. You can always email me at mdm5371@yahoo.com with any questions. I can share my number there.

Apparently I struggle with uploading. Thats supposed to be the pdf Marti report. To answer the question, build date is 4/7/73.

1973 for sale. Body is rough, frame is in good condition. Does not run, needs new brake lines. I attempted to revive it after it sat too long. I Don't think it would be too tough to get it running again.I installed a battery, new plugs/wires, and a new gas tank. It cranks, seems to lack spark...

I've owned 4 Early Broncos over the years and they've all been on the soft, and sometimes deep, Outer Banks sand from Carova to Ocracoke. It's GREAT on the beach, certainly as good as any JK. In fact, you can drive most anything, even basic all wheel drive, on the sand with enough clearance AND...

I've considered that. Removing the lift would require dealing with some steering linkage issues, no?

I'm in Richmond, VA. Picking it up today. Anyone got any ideas where I can get this job done near Richmond?

I bought my first, a 1970, 3 on-the-tree, with an angry 170 cubes under the hood in 1987. $1200 or so. 32 inch no name tires, one door a different color than the other, and a love affair began. Those teenage years of top off, wind in the hair, sand-wheeling, girl-chasing were exquisite. I've had...

@Johnnyb Yes. It's uncut, I'd like to get it back to stock height, I like the original look. I've got the original rims and hubcaps on it, so 2.5" high makes 235/75/15 look small. The only off-roading she'll see is OBX sand...

I went down there today. I measured the radius arms on my standard height '73, about 34" from axle to frame mounts, same on the '76. I'm confused as to what I should tell them. They work on mostly modern stuff, of course anything is modern compared to a 1976, but they say the radius arms are too...