• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Recent content by steward

  1. S

    Mig or Tig?

    Frankenhorse I have been doing sheetmetal fabrication for the past 20years,and I can tell ya they both have there specific place and application,for genneral use the mig is fine. Really just depends on what your doing.For instace welding the floor boards in my bobtail I used the mig ,But I just...
  2. S

    Quarter pannel seam help

    Can anyone please give me some advice?Iam currently rebuilding a 74,and when i bought it I found some flaking on the drivers side rear quarter seam.It was not all the way threw at that time just some pits,so I media blasted the seam and took a fine wire wheel to the pitted areas also to try to...
  3. S

    Floor board help

    thanks for the help t Thanks for the help guys I will keep you posted on how this restore goes thanks again Dan.S
  4. S

    Floor board help

    Can anyone give me some advice?iam currently replacing the floor boards in my 74,and some have told me to cut the old ones out ovelap the new ones about 1 inch over the old floor and weld it in, wouldnt this cause a bad place for moisture underneth? i realize that a butt joint would be difficult...
Top