Search results

Very nice mlarison. Fishinman78, did you have to do anything with steering/brake lines with your suspension setup?

Yes! Love it fishinman78!

Good looking ride B RON CO! I’m thinking I’ll end up with 2.5” suspension and 1” body lift. So pretty much your same exact stance. Mine will also end up blue, my original paint was grabber blue.

Ok, yes, they are 5.5” inside to inside. Thanks guys!

What was the width on the stock steel wheels? I just picked up some stock ford wheels for 30$ And noticed they are a little over 6 1/2” wide.?? Anyone running stock Steelies with 31x10.50s on their LUBR?? Let’s see your pics! My plan is to paint them and slap some hubcaps on them but wasn’t sure...

Thanks guys, makes sense! I’ll hang tight and just buy a stock radiator when the time comes. I’m about to start on floor pans so it will be out of service for a little while anyways!

So... 3.50 gears and 31x10.50s is going to be questionable with.. my rig has no plans on seeing rock crawling, just cruising.

I have come across a new radiator for a 302 manual. Came out of a 74. I’ve got a 74 with an automatic so my radiator has the trans cooler lines. This new one does not.. good idea? It’s hard to pass up with my radiator being no good but what are my options for the trans cooler? I’m sure I could...

Thank you Sir!

I’m sure this is out there but I’m not finding anything that matches mine.. I’m pretty sure these are stock on my 74 ranger.

It’s aluminum, hoping it will just last until I’m ready to rebuild motor. For now, I should be good to go

All put back together and idling like a champ! Thanks guys! Next up is brakes.. then rust removal...

Thanks again Paul

So if I wanted to go without the spacer.. how do I go about that and what do I need to know?? What would I do with the vacuum line that goes to pcv valve?? From what I understand, I need some type of spacer to keep the carb off the intake to keep it from boiling /evaporating the fuel in the carb?

Hopefully these pics post now.. I still don’t have one in hand but this is what I’m looking for..

Thanks guys, I think I have found one. Just gotta get my hands on it before I say the search is over.

No vacuum leaks that I know of but am in the very early stages of getting one running that had been sitting for quite a while.. I can’t get pics to upload.. I need to pay my 12$ in order to post pics from what I hear. I’ve got the carb cleaned and ready to go back on but just need a spacer.

I’ve got a 74 ranger with 302 and not sure of the Motorcraft carb.. either the 2100 or 2150. The spacer is junked so I’m looking for another stock spacer.. are these things impossible to find? I’d think I could find one that someone has replaced with new carb/intake. Out of the ones I’ve seen on...

Looks good guys