Search results

Just got the new tag for the Sequoia Brown 75 that we bought a couple of months ago. The wife wanted a breast cancer awareness tag so we were limited to 6 letters.

OK, I got the windshield in even though the gasket was a little bigger. My new windshield was a little smaller at the bottom and the gasket was a little bigger. For future reference in case anyone searches later. Next time I will just find a glass guy that will cut a new one from an original...

Gone. They done last long at that price.

Guys, I need a measurement on a windshield. I just picked up a new one and slipped the gasket on it and the gasket is almost an inch to wide on it. Seems to fit height-wise. I cant really get an accurate measurement from the old one in my 75 because of the lip on the gasket. Does anyone have...

PM sent.

PM sent, next in line

Back in April my son got married and used the Bronco as the "get-a-way" vehicle. We finally got the pictures back this week so I thought I would share one.

Steve, thanks for the reference, I saved the link for the future. I did find a blown fuse and the rest was just a matter of disconnecting and reconnecting. Thanks again. I can get this on the road now.

Fixed but still unsure about how for most of it. I traced all wires, disconnected, checked voltage and reconnected. Most connections looked like they have never been apart. Once connected front lights worked with flashers. And the rear brake light works again. Now for the embarrassing part. I...

With that much rust in the rockers, make sure you support underneath before you cut anything else out. Otherwise you will have some buckling happening.

I got issues with all of 'em! The biggest problem I can't figure out is why my flashers work on the tail lights but not on the front. I know they all go through the headlight switch but shouldn't they both (front and rear) be fed by the same "power" coming out of the switch? Where should I...

Not sure about the others but the cable you are holding in the third pic is the temp control for the heater. Nothing to do with the carb. The first maybe a manual choke cable???

That washer is the retaining washer and you need that to keep the spring from bending around the shoe basically, you can go without but use it if you got it. The spreader bar on top looks more like the one on my 75 but mine had a slight hump in the middle. I will see if I have a picture when I...

I did try tapping on the lugs while putting pressure on the drums, no joy. I will be pulling them apart this weekend and redoing everything. After my numerous travels underneath the Bronco replacing all of the brake lines, its obvious from the plethora of dirt-dobber nest that this truck has...

Thanks guys. I will go ahead and pull the hubs and get these brakes replaced and bearings repacked. Then I will be collecting the Ford disc parts for the future upgrade when I do the lift.

Attempted to replace the stock front brakes on my latest 75 this weekend and can not get the front drums off. They are not stuck on the brake shoes, I have backed off the adjuster enough adn the wheels spin freely. These seem to be seized on the lugs and hub. I used my torch and 3lb sledge to no...

Sign me up.

I just did the rears on my 75 last night and it has the 10" brakes. You could get either 10" or 11" brakes for several years. And, yes, you should have the adjuster cable and spreader bar.

The front looks like a 44 and the rear is a somewhat leaky 9".

I will most likely have to bend a piece to fit. Weird that my other 75 has the same bracket on the H-block. I saw the H-block at TBP referenced above and questioned mine as original. Thanks for the input.