Search results

The ground wire that attaches to the pump inside the tank want’t crimped properly causing insufficient/inconsistent grounding.

Vented through gas cap only, I just drained it and re tested, the pump still will not cycle . I had drilled a small hole in the gas cap for venting, and the 3/4” hose that comes up to filler neck area. No other venting system is being used. Purchased 11/2020 Brand New Tom’s Bronco 23 gal...

Well I thought I had this solved until I went to try and start this morning, no fuel pumping. Yesterday I drained the tank, lowered enough to put another ground strap on then filled up with a few gallons of gas and the pump came on and started. Tested this morning; Still getting 12 volts when...

Thank you sir! The braided ground strap had come loose inside the pigtail mount.

i have about 6 month run time on new build and about 1000 miles, throttle body fuel injection system with 23 gal efi tank with in tank fuel pump. Everything was fine until I tried to start last week and notice I couldn't hear the pump kick on. I tested volts at the wire and getting 12 plus...

Thanks for the help, I’ll adjust the toe in some and go from there.

7 degree c bushing

Thanks for the advice, so would sway bar help any drivability when tracking straight down the road? I can take my hand off the wheel and tracks straight, but when I hit some uneven areas, it tends to move side to side. Measurement on the Baja atz 315/70r17 are around 33-5/8” when I square off...

I have 9” between the top of axle housing and bottom of frame, tires are 315/70/17 Micky Thompson Baja Atz, I’ll attach another photo direct shot.

Here’s the alignment results and pictures of the suspension.

Wanted to get some feed back on the results from alignment shop specs. Late model 71 302 3spd, all new steering components, c bushings, 2.5 suspension lift w standard shocks, 1” body, new power steering, tires inflated around 28 psi. It rides ok, although has a slight shimmer or wandering at...

I put the pics in the garage, and sent them to you also. Thanks

Yes its the height when both hubs are off the vehicle and on a flat surface. One would push the wheel out further than the other one. Could’nt get my picture to upload to show you with the tape measure by it. I found out that Dana 44 hubs with drums had two different hubs. One that was cast...

Questions for y'all, working on a Wilwood disc brake conversion and found that one of my Hubs were shot because bearing sleeve fell out, purchased a good used one from a vendor and notice when placed flat the hub surface is about an 1/8 different from the originals that came of the 72 dana 44...