4R70W Flexplate part#

[kholding]

Just tried doing a search but want to make sure before I place an order or hoping to find a good place to buy a flex plate for my 4r70w/351W combo. Turns out the flex plate I have now isn't going to work (it bolted right up, hopefully I didn't damage the trans!). I know I need the 164 tooth, 11 7/16 or 11.4" converter bolt circle with 28oz in balance (for C4?). Does anyone have a part# and or place to purchase at a decent price? Summit seemed a little high and I'm not even sure if it is the right one. Also looking for a dip stick for the trans as well. I know there are a few options out there, just hoping I can find something that fits well under the trans tunnel. Thanks everyone.

 

[Viperwolf1]

http://www.bulkpart.com/2/product/FLYford/F200.html

 

[kholding]

Thanks Viperwolf.

 

[kholding]

Got it in the mail today! I can't imagine this will be the last goof up of my build. Looks like the right one, right? Now to pull the engine and get this one in there...

 

[Viperwolf1]

Looks good to me.

 

[rcmbronc]

Is that the same as the C4 flexplate?

 

[surfer-b]

Is that the same as the C4 flexplate?

The stock Explorer plate work just fine on my c4 when I did the Explorer conversion, no issues at all.

 

[bronco loco]

I also used the stock 5.0 explorer with no problem, just make sure the tc sits right.

 

[bigjhoov]

Depends what motor you're putting it on. If it's a 5.0 the stock 50oz. Explorer f/p will work. If putting it on a pre '83 motor, you need a 28oz f/p with 11 1/2" converter hole spacing.

 

[Viperwolf1]

Depends what motor you're putting it on. If it's a 5.0 the stock 50oz. Explorer f/p will work. If putting it on a pre '83 motor, you need a 28oz f/p with 11 1/2" converter hole spacing.

And all years for 351W are 28 oz.

 

[bigjhoov]

Ah, didn't read the 351w part.