kholding
Bronco Guru
Dana 44 from a 1976 F150- This is the stronger version of the D44 with the 0.5" thick tubes and welded-on wedges (which have been removed). This axle measures 65" WMS when built. All of the brackets have been already removed. Included is the housing/knuckles/cover/carrier. Tubes are clean and ready to be built up to your needs. I am selling for less than I have into this- $300.
Shaved Ford 9 inch housing- this is also from a 1976 F150 and was shaved by a 4x4 shop in California for additional clearance. It has 1/4" plate welded at the bottom. All brackets have been removed from the housing. Again, ready for you to build to your needs. This listing is for the housing and stock 31 spline axles. Total width on this is 65" WMS. $300.
Shaved Ford 9 inch housing- this is also from a 1976 F150 and was shaved by a 4x4 shop in California for additional clearance. It has 1/4" plate welded at the bottom. All brackets have been removed from the housing. Again, ready for you to build to your needs. This listing is for the housing and stock 31 spline axles. Total width on this is 65" WMS. $300.
Attachments
Last edited:
