9'' did you know?

[bax]

I was taking apart a gear case so I could clean it all up. I had a hub tool on the table. Did you know that these, fit this? Am old and I never knew this, fit that. So I thought I would share so some of you could say , You didn't know that? and others could say, wow I never knew that! At least we will all know after this.

 

[Yeller]

Thanks Bax for making me feel bad I should have shared. I thought that's what those were for and then worked on a D44 spindle too, LOL

Another tip on the same lines, a Dana 60 one works on the 3-1/4" bearing units for 35 spline axles.

BTW got a racer buddies that need a 4.30 35 spline pro gear with pinion support that is assembled to the pinion? It needs a home, if someone would pay the shipping I'd send it.

 

[bmc69]

wow. I never knew that.

And yes, you are old.

 

[bax]

Thanks Bax for making me feel bad I should have shared. I thought that's what those were for and then worked on a D44 spindle too, LOL

Another tip on the same lines, a Dana 60 one works on the 3-1/4" bearing units for 35 spline axles.

BTW got a racer buddies that need a 4.30 35 spline pro gear with pinion support that is assembled to the pinion? It needs a home, if someone would pay the shipping I'd send it.

I would pay the shipping

 

[bax]

wow. I never knew that.

And yes, you are old.

You sir are just a tad older.

 

[bax]

Thanks Bax for making me feel bad I should have shared. I thought that's what those were for and then worked on a D44 spindle too, LOL

Another tip on the same lines, a Dana 60 one works on the 3-1/4" bearing units for 35 spline axles.

BTW got a racer buddies that need a 4.30 35 spline pro gear with pinion support that is assembled to the pinion? It needs a home, if someone would pay the shipping I'd send it.

I happen to have a dana 60 hub tool. good to know

 

[Seventee]

I knew this but I don't remember when I figured it out. Maybe someone posted years ago? But even Bill should remember that...

 

[Madgyver]

i use a grinder wrench