Workin' on it. Bit of an update:
Aaron and Lane are workin' on building the frame and modifying the body. Lane's adding 5 or so inches of length behind the front seats, so we can keep most of the tail lights and the stock tailgate....I want it to keep the bronco look as much as possible. I've been fighting a bit with Whipple (who is HORRIBLE about calling back in any sort of good timeframe and delivering on order fulfillment) and the Hogan's intake custom intake, so that we get it right the first time.
Intake will have bungs for:
water temp 3/8" NPT
manifold surface temp 3/8" NPT blind hole
intake air charge temp 3/8" NPT, after intercooler in plenum
two 1/8" NPT bungs for vacuum/boost gauge and for MAP for Accel DFI (same thing, basically)
inlet for Snow Performance Methanol/Water injection. This is a backup idea...if the intercooler doesn't drop the air temp enough, then I'll add the Snow kit and inject before AND after the blower.
8 injectors. I ordered what I hope are extremely well matched, extremely low latency, high quality spray pattern injectors. Goal is to have steady idle and accurate fuel metering at low power levels as well as a high flow capability. The ones I chose are:
FiveO Black Ops 1000cc/min I may have gone a bit light for producing 1000hp at the crank if the bfsc is truly up around .65 or .70.....but with the intercooler, I'm hoping the bfsc comes in closer to an NA number of around .5 or .55.
Anyone want to start a pool on what breaks first? Could do two pools...engine and driveline. I'm wondering how well the crank will hold up personally...this is a modified 400 crank...the rods and pistons are very strong forged parts. Hell, might be block...we'll see. I've got another mill in mind if this one grenades.
Tranny is shipping tomorrow with any luck. Just got off the phone with Hughes about it..they're about a week late on it. They're welding on the billet adapter ring to the bellhousing now. However, I'm stoked about the custom 4l80e they're building for me and the custom torque converter. Should be pretty badass.
I do have other parts that have come in to post. Here's a couple:
This the dual sync billet distributor I'll be using with the Accel DFI...the dual sync lets me run this in SEFI mode.
This is the cam sync ring; independently adjustable from the timing. I've not played with one before...kinda neat.
This gear will have to get swapped for a brass one....the current cam in my motor chews these up and spits them out..which isn't good to have chewed up metal bits floating around in the oil. Lost two dizzy gears years back when I first put this cam in before I figured it out.
That's all for now. More updates to follow.