• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Body Disassembly Question

JHill1085

New Member
Joined
Mar 10, 2024
Messages
6
Hello all,
I have all of my drivetrain removed and am getting ready to build the cart to put the body on. In order to make it as light as possible to since I don't have a hoist or anything to assist with the process, I was thinking of removing some of the body parts (Fenders, grill, etc.) but want to make sure I don't remove anything that will cause the body to warp. I am going to brace the body in the door gaps and possibly the rear & front as well. Can someone offer some advice on the best way to go about this? Thanks
 

AZ73

Bronco Guru
Joined
Mar 28, 2012
Messages
3,813
I took off fenders, grill, doors, windshield, and tailgate. I use heavy L beams bolted at about a 90 degree angle, with the horizontal side bolted to the rear quarters using the holes for the top, and the vertical side bolted to the door hinge holes. Then I used a engine hoist to lift it. The one issue I ran into was my dolly was too low for the hoist to roll under so i had to raise it up off the ground a little to set the body down (see the wood under the front wheels of the dolly). The last picture is a better picture of the lifting jig I made. Some people just weld small pieces of steel rod across the door opening, but i wanted to ensure stability, and side by side didn't flex also. Plus it made it convenient to lift. The cross brace that the lift attaches to was not bolted, but held in place with vice grips so i could adjust it for center of gravity which was key. It helps if you have a friend or two to look for wires etc getting hung up but i was able to do it by myself.


IMG_4980.JPG
 

Attachments

  • IMG_4981.JPG
    IMG_4981.JPG
    303.9 KB · Views: 99
  • IMG_4985.JPG
    IMG_4985.JPG
    304.8 KB · Views: 87
  • IMG_4966.JPG
    IMG_4966.JPG
    183 KB · Views: 97
Last edited:

jeffncs

Contributor
Bronco Guru
Joined
May 4, 2004
Messages
1,898
Loc.
Raleigh, NC
The other option is to drag 3-4 buddies over and each grabs a corner. They’re not heavy once stripped down…

I moved the first body onto a cart using 2 engine hoists. The second body went onto the cart a lot easier with strong backs.

That first body went onto its frame using an engine hoist and backs.
 
Last edited:

jeffncs

Contributor
Bronco Guru
Joined
May 4, 2004
Messages
1,898
Loc.
Raleigh, NC
Word of caution regarding the body cart…. It’s darn close and certainly convenient for body work…..but it’s not perfect and final panel alignment will need some “help” once it’s on the frame.
 
Top