- Joined
- Nov 3, 2003
- Messages
- 51,618
Don’t assume the wrong front springs at this point. The rear is so far down, it could be skewing the results of your measurements in the front.
That 1 inch is within the range, I would think.
Easiest would be to jack up the rear bumper until the vehicle looks relatively level, and measure the front again.
A picture of the rear springs for us to look at, wouldn’t be bad idea either. It certainly looks low in the rear, even for a stock bronco. But it is always hard to tell from pictures.
That 1 inch is within the range, I would think.
Easiest would be to jack up the rear bumper until the vehicle looks relatively level, and measure the front again.
A picture of the rear springs for us to look at, wouldn’t be bad idea either. It certainly looks low in the rear, even for a stock bronco. But it is always hard to tell from pictures.
