C-Clip for D20 Needed!

[DualDawg]

Anyone know the size... thickness/diameter or a part number and where to get the C-clip that holds the gear on the input shaft on the T-shift style D20 T-case? Thanks. Jerry (San Jose)

 

[broncodriver99]

I've never seen one available individually. Your best bet would be to call one of the vendors. They should be able to tell you. Tom's has a lot of used stuff so they may have one laying around.

 

[Hoppy]

Six States Distributors in Portland Oregon should have or be able to get it.
If you are OK with used one Call Toms Bronco Parts

 

[Viperwolf1]

Id is 1.320", od is 1.620", thickness is 0.065".

 

[DualDawg]

Thanks for the repies and info! I ended up getting one from a fellow Bronco addict nearby. I will keep this info for future use. Thanks again. Jerry