Jerrod4567
Full Member
Congratulations man thats awesome!
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
CB.com Giveaway!!! - Driver side cover!! sponsored by TOFIC - Ends 5/8/07
- Thread starter TOFIC
- Start date
Congratulations man thats awesome!
HotWheels
Bronco Guru
OP
OP
TOFIC
Bronco Wrencher and Fixer
SMOKE it is not a problem.
I am having difficulty getting the other winner (JON the admin, see the rules on the first posting) he seems to be reluctant to send his address so he can get his plate. How about it fellas, a little persuasion from you guys must get JON's fingers in gear and send his address so he can get his cover.
TOFIC
HotWheels
Bronco Guru
Hey guys..here's an idea. Acid etching of the glass covers. Bronco, Cobra, Owners or Bronco's name Images and other info can be done pretty easily. Just a thought...
Skiddy
Bronco Guru
- Joined
- Oct 8, 2003
- Messages
- 11,560
Email sent TOFIC. Thanks again!
OP
OP
TOFIC
Bronco Wrencher and Fixer
Acid etching of glass?? not going to happen in my lifetime. The plates have the same properties as glass in this case. There is a way to mark them Mick but it is exceedingly expensive. you can engrave them using a carbide bit or sand blast them use tungsten carbide media. Both ways are way to expensive for my liking almost double the cost of the plate depending on the pattern
TOFIC
OP
OP
TOFIC
Bronco Wrencher and Fixer
JON
Lost your email please resend (red faced and looking sheepish)
TOFIC
Lost your email please resend (red faced and looking sheepish)
TOFIC
OP
OP
TOFIC
Bronco Wrencher and Fixer
I did resend it. I'll send it again now.
Similar threads
