• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Centech Firewall Grommets

Dbarnes72

Sr. Member
Joined
Mar 18, 2009
Messages
643
Loc.
Eastern Wa.
Anybody have a fight with these things besides me?? Trying to get the (2) harness grommets to seat in the firewall holes but they aren't very well suited to the purpose (or so it seems) the holes are "fluted" outwards making probably a 1/4" effective firewall thickness. The grommets have maybe 1/8" groove/seat. Think I'm going to try some wire pulling lube. May silicone sealant?? Thoughts? The Centech harness is pretty nice but you definitely have to work at a couple of the things. Wire color..........nearly non-existent manual etc....Vent complete..
 

Dannyboy71

Sr. Member
Joined
Feb 23, 2011
Messages
420
My grommets were actually a little loose in the fire wall holes . I put some black RTV on the grommet stuck it in the hole then cleaned up any excess. My RJM grommets were really tight, (pita) used some dish soap and pulled it in with pliers. Be careful not to rip the grommet if you are using tools to get them in place.
 

Blue71

Contributor
Bronco Guru
Joined
Aug 27, 2001
Messages
5,151
On my 71... They wouldn't go throught the holes from the backside, and body was already painted so I used a quality black caulk and coated the grommet, held it in place , and it stayed there well.

Hope that helps,

Blue71
 

904Bronco

Contributor
Bronco Guru
Joined
Sep 28, 2004
Messages
6,720
Loc.
San Martin, CA
I used silicon spray to help them slide in...

1st one I did the grommets were loose in the holes, a couple of taps with a punch around the holes fixed that. (A BCB recommendation)
 
OP
OP
Dbarnes72

Dbarnes72

Sr. Member
Joined
Mar 18, 2009
Messages
643
Loc.
Eastern Wa.
Thanks all for the advice. I think the wire lube would probably help out but if you go down that road it probably isn't going to clean up too good. Caulking/ RTV sounds like the way to go. They would probably work if you were going into fresh drilled holes.
 
Top