• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Centech Harness Routing

stokers

Full Member
Joined
Jun 27, 2009
Messages
187
Loc.
Richmond, KY
I have a '69 Bronco and am installing a Centech harness. Instructions show I should route the harness through the passenger's side and driver's side of the firewall. My question is where is the best location to run the harness through on each side since the holes are not already there? In my Bronco the factory harness went through one hole in about the center of the firewall behind the engine. Also, what size hole should I drill to best fit the grommet? Any help would be great.

Thanks!
Bob
 

Sporto

Sr. Member
Joined
Oct 10, 2005
Messages
923
Hi Bob,
Yes, you need to drill the two holes in the upper corners of the firewall on the driver's and passenger's side. There are two grommets on the harness that will seal these off and honestly to me it looks a lot cleaner than the firewall junction that the OEM wires use. I am not sure of the diameter of the hole that needs to be drilled, but I know that the manual explains it pretty clearly.

If you don't have the Centech manual, then search on here it has been shared in .pdf form many times in various threads.

I can post pix if you need me to.

Good luck.

Rich
 
OP
OP
stokers

stokers

Full Member
Joined
Jun 27, 2009
Messages
187
Loc.
Richmond, KY
That would be great if you could post a pic of your firewall with the harness going through. I'll take another look at the manual to see if I can find the hole diameter.

Thanks,
 

joshnjulie1

Sr. Member
Joined
Jul 11, 2012
Messages
891
Loc.
Moreno Valley, Ca
Get the cheap large uni-bit from HF and go one step at a time. I had to do the same. I installed the same harness about 6 months ago. The harness is stiff enough to pull the grommet out of the hole so be thinking about that when you install. The one on my pass side likes to sit sideways. I should have drilled it a little closer to center. just keep that in mind. Good luck
 
Top