• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

close ratio steering box?

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Has anyone swapped the close ratio steering box from WH or other venders onto a bronco that had factory PS? If so how bolt on was it? I want to swap to this while I get my orginal box rebuilt if its still rebuildable but I want to be able to put the stock box back on and retain the new one for my next project. I'm mostly concerned about the steering shaft. Thanks
 

mg70bronco

New Member
Joined
Mar 24, 2004
Messages
26
Loc.
San Carlos CA
you will have to cut the lower shaft at the joint to mount the new steering joint on. that was the only non-bolt on thing I had to do.
so unless you want to weld the original back on your steering shaft will need to be replaced as well. I personally love my steering box from Toms. It's three turn and seems very well built.
Mike
 

blksn8k

Sr. Member
Joined
Sep 28, 2003
Messages
528
I have the Tom's 3.1 turn box as well. They supplied me with a piece of 3/4" dia shaft with one end splined to match the factory style u-joint at the lower end of my steering column. I had to cut the other end to length and machine it to fit the end of a Flaming River u-joint which was made to fit a 3/4" "D" shaft. Unfortunately, I had to make a u-joint from two different joints so that I had one end with the 3/4" "D" and the other with a 17mm "D" that fits the input shaft on the 3.1 box. I imagine you can buy a joint with that combination but I just "happened" to have two different joints that I could make the correct combination from. Don't ask, it's a long story. %) BTW, the 3/4" shaft was not part of the Tom's kit but they do give you a Flaming River u-joint to fit the new box. What I was not satisfied with was the fact that the other end of the u-joint they supplied was designed to be welded to your stock shaft. In my case a previous owner had added a 76-77 style box and for a bunch of reasons I could not use the existing lower shaft.
 
OP
OP
B

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Thanks for the info I think I can live with that modification anything for better steering.
 
Top