• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Clutch size for NP435

Mac2Night

Bronco Guru
Joined
Aug 10, 2005
Messages
2,204
So I may or may not keep the NP435 that is installed in my father in law's EB. When he bought it the transmission and t/c were installed but the motor was out. We will be installing a motor in the coming weeks but I don't know what size clutch it needs. Would it be the same size as a stock 3spd as it is using the 302 bell housing? 10" OR 11"?

Thanks for the help!
 
Last edited:

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
Yes x2
As long as it's the stock original cast-iron housing (some early models did use aluminum though) the 11" clutch is what most V8 Broncos came with.
Double check your flywheel's bolt pattern though, as that along with the size of the bell housing are pretty much what dictate things like this.

For starters, count the ring-gear teeth. If it's 157 then someone installed the smaller car version and you'd probably not fit an 11" clutch cover. If it's 164 teeth on the other hand, at least it's the proper diameter and will more likely have the 11" pattern.

I guess there is also a "large" 11" pattern, but I'm not sure about all the subtleties here. I always just called them 10's and 11's too, so I could be a little off-base.

Paul
 

KyleQ

Bronco Guru
Joined
Apr 24, 2008
Messages
5,480
11" - head to your local parts store and get a clutch for a 80's Ford pickup that had a NP435. Order the 11" flywheel and clutch kit from them - cheap and strong. I clutch dumped my setup with 4.11 gears and 43" tires thousands of times and it held strong every single time.
 
Top