marks bronco
New Member
I needed to replace my throut out bearing in my 68 3 speed and have everything dropped from the truck. Now when i turned the trans over fluid started leaking from the plat like theres a weep hole. Is that supposed to be a vent of some kind? and now that its half drained what kind of oil goes back in it? also ive never done the 3 finger type clutch befor so does the through bearing clip to the fork arm and rest against the inside or outside the 3 fingers and now most important I will be separating the transfer case from the trans at the adapter on the trans and heard someone once mention that theres a tool to keep the trans in 1st gear or else the bearings in the trans could fall out. Anyone heard of this or have any guidance!