• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Column shift handle spring

johnbeck

Sr. Member
Joined
Aug 11, 2015
Messages
534
The spring on a pin under the column shift handle is broken in three pieces. I've tried to find a vendor with the spring -no luck. The spring is pretty sturdy and I'm trying to figure out where a spring of it's stoutness might be used. Any thoughts? Thanks. (1973 Auto shift column)
 
OP
OP
J

johnbeck

Sr. Member
Joined
Aug 11, 2015
Messages
534
The 1 inch long spring is over a 1/8th inch diameter, 1 1/2" long pin that. is in the steering column shift collar and applies spring tension to the bottom side of the auto shift lever. The spring/pin is held in place by two phillips screws.
 

jckkys

Contributor
Bronco Guru
Joined
Mar 15, 2012
Messages
5,221
I found a spring at ACE that I cut to length. It worked for many yrs. and I got it the day I needed it. A little heat is needed to square the ends. The electric range works so does a propane torch. I think it's stainless steel too.
 
Top