Dana 20 Needle Bearings

[tehachapi68]

OK, so I screwed up.

I pulled my Dana 20 out for transmission work, but managed to lose a couple of the needle bearings that support the transmission's output shaft on the input side of the Dana 20.

Do you have a "parts" D20 laying around that I could buy a few of the needle (or roller) bearings from? You could just throw them in a padded envelope and mail them to me.

They are about 0.312" (5/16" nominal) diameter by about 0.559" (9/16" nominal) long.

I have 11 originals -- I think a complete set is 13, right?

Thanks!

 

[Skiddy]

OK, so I screwed up.

I pulled my Dana 20 out for transmission work, but managed to lose a couple of the needle bearings that support the transmission's output shaft on the input side of the Dana 20.

Do you have a "parts" D20 laying around that I could buy a few of the needle (or roller) bearings from? You could just throw them in a padded envelope and mail them to me.

They are about 0.312" (5/16" nominal) diameter by about 0.559" (9/16" nominal) long.

I have 11 originals -- I think a complete set is 13, right?

Thanks!

yes 13 is correct, some tranny shops in your area may have some as well.

 

[Blue71]

I just bought a new set (13 ) from Jeff's Bronco Graveyard for a D20. Worked great.


Blue71

 

[70_Steve]

I know I had the old ones, from my rebuild, up until two weeks ago. Then I moved, and can't remember if I threw them away or packed them. I'll look tonight and let you know...