• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Dana 44 Bearings?

Tram

Bronco Guru
Joined
Mar 21, 2005
Messages
1,203
Need to replace the wheel bearings on my D44.

I’ve got an unknown parts build disc conversion, but I’m fairly certain I’ve got a Ford rotor/hub. The hub is 5x5.5 spacing, I don’t think Chevy used that.

So, I’m feeling comfortable that I can order sets 37 and 45 bearings and be in business, but before I ordered them up, I’d run it by the experts here.
 

SLOWnEASY

Contributor
Sr. Member
Joined
Sep 26, 2022
Messages
526
Loc.
San Diego, Ca.
Do you need it to be able to drive while you order parts? If not I would pull a hub and look at the bearing numbers. That will get you the exact parts needed.
 
OP
OP
Tram

Tram

Bronco Guru
Joined
Mar 21, 2005
Messages
1,203
Do you need it to be able to drive while you order parts? If not I would pull a hub and look at the bearing numbers. That will get you the exact parts needed.

Nah, it's getting too cold. I don't have heat. :)

That said, I think sets 37 and 45 from Timken have me covered.
 

jamesroney

Contributor
Bronco Guru
Joined
Sep 11, 2007
Messages
2,607
Loc.
Fremont, CA
Nah, it's getting too cold. I don't have heat. :)

That said, I think sets 37 and 45 from Timken have me covered.
Yes, if you are going Timken...it's SET-37 and SET-45.

If you are going National, it's A35, and A37.
BCA, SKF, ACDelco, and everybody else...it's some variant of *35, and *37.

Personally, I don't go out of my way to source Timken anymore. Their distribution channel is absurd. Last set I bought came from India, and cost double.

The A37 and SET45 both use the LM501310 / LM510349 components. (1.781 ID, 3.062 OD) Exact same parts in a different box. If you really want to pay extra for the same bearings...you can buy the races separately.

I did buy a very nice set-20 from "master-pro" a few years back...and found a US made Timken in the box.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
Personally, I don't go out of my way to source Timken anymore. Their distribution channel is absurd. Last set I bought came from India, and cost double.
First time I had to replace a unit bearing on my Buick I wanted a Timken from Winchester Auto, which back then was my usual go to. The other brands you mentioned were in the 80 to 120 range, while the Timken was 250!
They said to wait as they were working on a deal with the different distributor, or perhaps through the manufacturer through their network. Anyway, the next time I went in, I ordered a Timken and it was available for $89.
So sometimes it depends on who you’re buying from. Or more correctly, who they are buying from.
 
Top