Dash mounting

[74midnightblue]

The rear lip of my dash was rotten so I cut it out and welded new metal in. I do not know where the slits are suppose to be. It is hard to explain without a visual but if anyone knows what I am talking about please help me. What are the measurements of solid metal to where it is cutout to mount to the body measurement of what is cutout etc.....

 

[74midnightblue]

My bronco is a 1974. I am going to try to describe this better now. On the back side of the dash the the lip of metal there rotted so i cut that out and welded a new lip in. There were areas cutout for mounting I need to know the dimensions to cut out what needs to be cut out. If the dash is backwards there should be a couple inches of metal then a square cut out more metal a rectangle shape cut out more metal a rectangle cut out more metal ane then anoter square. I am not sure because it was rotten and was just hoping someone had a dash that is good and could give me the correct dimension. I really hope I can get an answer so I can get the dash all done and start working on more parts. Thanks

 

[shamu]

Does this help? If you need something else pic wise ask another question and I will see what I can do.

 

[Izzy]

Shamu, would you sell me that dash already?

 

[74midnightblue]

yes that did help Shamu thanks.