• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Desktop Dyno

Joe473

Sr. Member
Joined
Jul 16, 2012
Messages
958
Does anyone have access to software that takes head flow numbers, cam specs and carb flows to predict torque and horsepower curves? Is there anything free out there or cheap that works with good results? I'm interested in plugging some numbers in on my 347.

Thanks,

Sent from my SM-G960U using Tapatalk
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
Haven't seen that in about 25 years. My old 386 computer really choked on that math. I so badly wanted that 387 math co-processor so I could run the program more. It was a good guessing tool, but there were also a LOT of assumptions. It always said headers made way more power than manifolds, but didn't give any concession to how good of a manifold or a header it was. I doubt I still have that floppy disk anymore.
 
Top