Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.
This is where all the old posts go so they can still be used for reference and searched.
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
If you have problems registering or can't log into your account, please contact Admin.
I plan to do some fairly deep water crossings this weekend, I have vent extensions on the diffs, but don't know if the transfer case has a vent I can raise up to keep water out. Any ideas?
Yeah, remove the vent, just above the output shaft yoke. It doen't unscrew, so just pry and twist... Leave a hole that's just the right size for a 1/4" NPT tap. I just did this on my t-case, but mine's on the workbench being rebuilt. Not sure if you'd want to have all that iron going down inside the t-case. If you've got a new gasket, pull the rear OP shaft housing off, tap the vent hole, then reinstal the housing...
JB weld works wonders. Just put a weatherhead fitting there and slap some JB on it. Just make sure you get all around the fitting and it will be water tight.