Door Alignment problem

[BroncoBub]

Drivers door is an original door can't seem to figure out why the top right edge won't line up. Any suggestions would be appreciated. Door is pretty square except for the top edge.

Thanks, Bub

 

[abn373]

My original doors never lined up well with the aftermarket metal fenders front fenders. The curve just wasn't the same, so no amount of adjusting in or out would make them align. They were actually worse than yours by a little bit. I am not a bodywork person and don't have a solution, I am just saying that for me it wasn't the doors, it was the fenders that were off.

 

[BroncoBub]

My after market fenders line up good. It’s the top rear of the door that doesn’t line up with the original upper quarter panel. Thanks for replying though.

 

[Rustytruck]

rear quarter out of square shove the bed back also this was good enough for ford when they made the Broncos since they were utility trucks.

 

[MitchE]

that looks better than mine and I have been playing with shims from WH for a year now.

 

[BroncoBub]

rear quarter out of square shove the bed back also this was good enough for ford when they made the Broncos since they were utility trucks.

ok I'll give it a try, thanks

 

[BroncoBub]

that looks better than mine and I have been playing with shims from WH for a year now.

It's only been two days, I'll figure it out. It lined up once before when I was test fitting everything now...not sure why or what I did. Thanks